1. | What is the meaning of the designation ‘M30' concrete suggested for a reinforced cement concrete work ? | |
2. | The Los Angels abrasion value requirement for coarse aggregates used in water bound macadam for the base course is ? | |
3. | In estimation of quantity of plastering work, quantity of deduction for openings allowed for 2 m² is ? | |
4. | Which of the following is NOT a mode of failure in a tension member ? | |
5. | A steel rod of 20 mm diameter is used as a tie member in a roof bracing system, and may be subjected to possible reversal of stress due to wind load. What is the maximum permissible length of the member? (Assume slenderness ratio=350) ? | |
6. | In an irrigated area 12 m3/s of water is diverted to a 0.32 km ^2 field area for four hours. The soil moisture measurement in the field done after irrigation showed that 0.4 m of water has been stored in the root zone. The water application efficiency (correct to nearest decimal) in this case is ? | |
7. | In which of the following wastewater treatment units is organic matter destroyed and stabilised by anaerobic bacteria ? | |
8. | Void ratio is defined as the ratio of ? | |
9. | A 30 m tape was tested before a survey and found to have a length of 29.93 m. If the length of a line measured with this tape is 270 m. find the true length of the line ? | |
10. | From among the different pollutants listed that cause air pollution, identify the secondary air pollutant. ? | |