1. The standard IF value for AM receiver is ?

107 KHz

455 MHz

455 KHz

10.7 MHz

Answer: 455 KHz

Explanation:


2. In a super heterodyne receiver ?

The IF stage has better selectivity than RF stage

The RF stage has better selectivity than IF stage

The RG stage has same selectivity than IF stage

None of the other options

Answer: The IF stage has better selectivity than RF stage

Explanation:


3. In a super heterodyne receiver, if the intermediate frequency is 10.7 MHz and the carrier frequency is 89.6 MHz, the image frequency is ?

78.9 MHz

100.3 MHz

111 MHz

121 MHz

Answer: 111 MHz

Explanation:


4. Which type of capacitor is used in radio receiver for tuning purpose ?

Mica gang

Trimmer

Miniature PVC gang

Ceramic Capacitor

Answer: Miniature PVC gang

Explanation:


5. The bandwidth required for baseband signals for FM radio is generally ?

Up to 150 KHz

0.5 to 1.5 KHz

0.3 KHz to 3 KHz

Up to 15 KHz

Answer: Up to 15 KHz

Explanation:


6. A squelch circuit in a TV receiver is used to ?

Cut off IF when AGC is maximum

Cut off audio amplifier when carrier is absent

Cut off IF when AGC is inoperative

Cut off brightness circuit when AGC is inoperative

Answer: Cut off audio amplifier when carrier is absent

Explanation:


7. For direct reception of TV signals from a communication satellite the type of antenna required is ?

Horn

Parabolic

Chicken mesh

loop

Answer: Chicken mesh

Explanation:


8. Maximum value of signal to noise ratio of an 8- bit ADC with an input range of 10 V will be ?

50 dB

43.8 dB

48.9 dB

49.8 dB

Answer: 49.8 dB

Explanation:


9. Noise figure of an amplifier depends on ?

Bandwidth

Output power

Power input

None of these

Answer: None of these

Explanation:


10. The term "white noise" refers to the following ?

A random signal with flat power spectral density

A random signal generated by beat signal

A random signal with long range correlation

All of the above are true

Answer: A random signal with flat power spectral density

Explanation: