| 1. | Which among the following is the correct statement ? | |
|
a clearance fit always provides interference
|
||
|
a interference fit always provides clearance
|
||
|
an interference fit may some time provide clearance and sometime interference
|
||
|
a transition fit may some time provide clearance and some time interference
|
||
View Answer
Discuss in Forum
Report Question| 2. | In transition fit size of shaft ________ hole size ? | |
|
is more than
|
||
|
is less than
|
||
|
is equal to
|
||
|
can be more or less than
|
||
| 3. | A pin is fitted in a hole. The tolerance zone of the pin is entirely above that of hole. The fit obtained will be ? | |
|
clearance fit
|
||
|
transition fit
|
||
|
interference fit
|
||
|
none of the above
|
||
| 4. | Tolerance is given to the part size to ? | |
|
increase the production
|
||
|
decrease the production
|
||
|
finish the components approximately
|
||
|
produce the parts within the required permissible size error
|
||
| 5. | Threaded component both external and internal are manufactured with thread tolerance. One of the reasons for having thread tolerance is to ? | |
|
ensure interchangeability of threaded parts
|
||
|
identify and group up threaded assemblies by labelling
|
||
|
determine the percentage of thread of both bolt and nut
|
||
|
obtain qualitative surface finish
|
||
| 6. | A shaft whose upper division is zero is called shaft basis, which one of the following letters indicates basic shaft ? | |
|
E
|
||
|
h
|
||
|
G
|
||
|
H
|
||
| 7. | In interference fit size of shat is _________ than hole size ? | |
|
small
|
||
|
greater
|
||
|
equal
|
||
|
none of the above
|
||
| 8. | When tolerance is given on one side of the basic dimension, it is called ? | |
|
tolerance system
|
||
|
allowance system
|
||
|
unilateral
|
||
|
bilateral tolerance
|
||
| 9. | What is the advantages of mass production ? | |
|
Cost and time reduced for manufacturing
|
||
|
Initial expenditure is low
|
||
|
Jigs and fixture are not needed
|
||
|
Special purpose machines are not necessary
|
||
| 10. | In a ________________ the minimum permissible diameter of the shaft is larger than the maximum allowable diameter of hole ? | |
|
clearance fit
|
||
|
transition fit
|
||
|
interference fit
|
||
|
slide fit
|
||