| 1. | If the width and thickness of a structure is small in comparison to its length, it is Known as ? | |
|
one dimensional structure
|
||
|
two dimensional structure
|
||
|
three dimensional structure
|
||
|
none of these
|
||
View Answer
Discuss in Forum
Report Question| 2. | Rolled steel beams are designated by the series to which beam sections belong, followed by ? | |
|
depth of the section and weight per metre length of the beam
|
||
|
depth of flange and weight per metre length of the beam
|
||
|
width of flange and weight per metre length of the beam
|
||
|
width of web and weight per metre length of the beam
|
||
| 3. | A steel plate is 300 mm wide and 10 mm thick. A rivet of nominal diameter 18 mm is driven. The net sectional area of the plate is ? | |
|
1800 mm²
|
||
|
2805 mm²
|
||
|
2820 mm²
|
||
|
3242 mm²
|
||
| 4. | As per Indian standards, rolled steel I-sections are classified into ? | |
|
four series
|
||
|
five series
|
||
|
six series
|
||
|
seven series
|
||
| 5. | The ratio of transverse strain to the longitudinal strain under an axial load is known as ? | |
|
tangent modulus of elasticity
|
||
|
bulk modulus of elasticity
|
||
|
modulus of rigidity
|
||
|
Poisson's ratio
|
||
| 6. | The angle of inclination of lacing bars with the longitudinal axis of the component member should not be ? | |
|
less than 40?
|
||
|
more than 70?
|
||
|
both (a) and (b)
|
||
|
none of these
|
||
| 7. | The rivet line is also known as ? | |
|
scrieve line
|
||
|
back line
|
||
|
gauge line
|
||
|
all of these
|
||
| 8. | Rolled steel flats designated by 50 ISF 8 means that the flat is of ? | |
|
50 mm length and 8 mm thick
|
||
|
50 mm width and 8 mm thick
|
||
|
50 mm thick and 8 mm length
|
||
|
50 mm thick and 8 mm width
|
||
| 9. | The distance measured along one rivet line from the centre of a rivet on it to the centre of the adjoining rivet on the adjacent parallel rivet line, is known as ? | |
|
staggered pitch
|
||
|
alternate pitch
|
||
|
reeled pitch
|
||
|
any one of these
|
||
| 10. | In designing a riveted joint, it is assumed that ? | |
|
load is uniformly distributed among all the rivets
|
||
|
rivet hole is completely filled by the rivet
|
||
|
friction between plates is neglected
|
||
|
all of the above
|
||