| 1. | A rolled I-section provides ? | |
|
large moment of inertia about X-axis with less cross-sectional area
|
||
|
large moment of resistance as compared to the other sections
|
||
|
greater lateral stability
|
||
|
all of the above
|
||
View Answer
Discuss in Forum
Report Question| 2. | The structure large in two dimensions and small in third dimension, is called a ? | |
|
supporting structure
|
||
|
surface structure
|
||
|
space structure
|
||
|
none of these
|
||
| 3. | When the line of rivets does not lie in the direction of stress, the maximum pitch in a riveted joint should not exceed ? | |
|
12 t or 200 mm whichever is less
|
||
|
16 t or 200 mm whichever is less
|
||
|
24 t or 300 mm whichever is less
|
||
|
32 t or 300 mm whichever is less
|
||
| 4. | A single triangular system is formed in the case of ? | |
|
single lacing
|
||
|
double lacing
|
||
|
both (a) and (b)
|
||
|
none of these
|
||
| 5. | When the components of built-up column are connected by a lateral system, the reduction in buckling strength due to shear deflection is ................ that of solid built-up columns ? | |
|
equal to
|
||
|
less than
|
||
|
more than
|
||
|
none
|
||
| 6. | In direction restraint condition of column ? | |
|
end of the column is free to change its position
|
||
|
rotation about the end of column can take place
|
||
|
end of column is not free to change its position
|
||
|
rotation about the end of column can take place
|
||
| 7. | Which of the following statement is wrong ? | |
|
When the unsupported lengths of the columns are reduced by providing intermediate supports, then the smaller sections may be used at a higher average stress
|
||
|
In a rolled steel I-section, the radius of gyration about Y-axis is much more than the radius about X-axis
|
||
|
When a column is subjected to different bending moments in two directions, the greater of gyration value of the radius of gyration should be kept in the direction of greater moment
|
||
|
all of the above
|
||
| 8. | Which of the following statement is correct in designing a laced column ? | |
|
A single lacing system on opposite planes shall preferably be in the same direction so that one is shadow of the other
|
||
|
The laced compression members are to be provided with tie plates at middle
|
||
|
The lacing bar should only be flat angle channels generally
|
||
|
The slenderness ratio of the lacing bars for compression shall not exceed 180
|
||
| 9. | If the tension member is normally acting as a tie in roof truss but subjected to possible reversal stress resulting from the action of wind, the member should have slenderness ratio not greater than ? | |
|
150
|
||
|
280
|
||
|
350
|
||
|
450
|
||
| 10. | A beam is a structural member subjected to .......... loads ? | |
|
axial
|
||
|
transverse
|
||
|
axial and transverse
|
||
|
none
|
||