| 1. | A two dimensional structure is also called ........ structure ? | |
|
line supporting
|
||
|
surface
|
||
|
space
|
||
|
none
|
||
View Answer
Discuss in Forum
Report Question| 2. | Which of the following statement is wrong ? | |
|
In single lacing, the thickness of flat lacing should not be more than 1/40th length between inner end rivets
|
||
|
In double lacing, the thickness of flat lacing should not be more than 1/60th length between inner end rivets
|
||
|
In riveted construction, effective length of lacing bars in single lacing is adopted as the length between inner end rivets
|
||
|
none of the above
|
||
| 3. | When the minimum size of the fillet weld is greater than the thickness of the thinner part, the minimum size of the weld should be ......... the thickness of thinner part ? | |
|
equal to
|
||
|
less than
|
||
|
more than
|
||
|
none
|
||
| 4. | When the load does not pass through the shear centre of the beam, it produces ? | |
|
torsional moment only
|
||
|
bending moment only
|
||
|
torsional moment along with the bending moment
|
||
|
none of the above
|
||
| 5. | The battening is preferred when the ? | |
|
column is axially loaded
|
||
|
space between the two main components is not very large
|
||
|
both (a) and (b)
|
||
|
none of these
|
||
| 6. | When upper column does not provide full bearing area over lower column, the bearing plate provided is designed by assuming that ? | |
|
the bearing plate act as short beam to transmit the axial load to the lower column section
|
||
|
the axial load of the column is taken up by flanges
|
||
|
the load transmitted from flanges of upper column and reaction from flanges of lower column are equal and form a couple
|
||
|
all of the above
|
||
| 7. | The batten plates used to connect the components of built-up column are designed to resist ? | |
|
longitudinal shear
|
||
|
transverse shear
|
||
|
moment arising from transverse shear
|
||
|
none of these
|
||
| 8. | When compression members are overloaded, then their failure takes place because of ? | |
|
direct compression
|
||
|
excessive bending
|
||
|
bending combined with twisting
|
||
|
any one of these
|
||
| 9. | In a tension member, the failure will occur in zig-zag line if the gauge distance is .................. pitch of rivets ? | |
|
equal to
|
||
|
less than
|
||
|
more than
|
||
|
none
|
||
| 10. | A tension member subjected to axial tension is designed on the basis of its ? | |
|
load carrying capacity
|
||
|
net sectional area
|
||
|
gross-sectional area
|
||
|
all of these
|
||