| 1. | The effective length of fillet weld should not be less than ? | |
|
the size of weld
|
||
|
two times the size of weld
|
||
|
three times the size of weld
|
||
|
four times the size of weld
|
||
View Answer
Discuss in Forum
Report Question| 2. | A steel wire when used as a tie requires ? | |
|
no prestressing
|
||
|
nominally prestressing
|
||
|
pretensioning to its full capacity
|
||
|
prestressing to half it capacity
|
||
| 3. | In combined footing, the shape for the base of footing should be .......... to support two equal column loads ? | |
|
rectangular
|
||
|
trapezoidal
|
||
|
triangular
|
||
|
circular
|
||
| 4. | The failure of a column depends upon ? | |
|
weight on column
|
||
|
length of column
|
||
|
cross-sectional area of column
|
||
|
slenderness ratio of column
|
||
| 5. | The number of batten plates should be such that it divides the column longitudinally in atleast ............... parts ? | |
|
two
|
||
|
three
|
||
|
four
|
||
|
five
|
||
| 6. | In riveted construction, effective length of lacing bars in double lacing is adopted as.......... times the length between inner end rivets ? | |
|
0.4
|
||
|
0.7
|
||
|
1.2
|
||
|
1.8
|
||
| 7. | A fillet weld whose axis is at right angles to the direction of the applied load is known as ? | |
|
side fillet weld
|
||
|
end fillet weld
|
||
|
diagonal fillet weld
|
||
|
all of these
|
||
| 8. | Rivet value is equal ? | |
|
strength of a rivet in shearing
|
||
|
strength of a rivet in bearing
|
||
|
minimum of the value obtained in (a) and (b)
|
||
|
maximum of the value obtained in (a) and (b)
|
||
| 9. | The lateral system used in built-up columns, to carry the transverse shear force, is ? | |
|
lacing
|
||
|
batten plates
|
||
|
perforated plates
|
||
|
any one of these
|
||
| 10. | Indian standards recommend that for a splice plate, rivets or bolts carrying calculated shear stress through a packing greater than 6 mm thick should be increased above the number required by normal calculations by ? | |
|
1.5% for each 1 mm thickness of packing
|
||
|
2.5% for each 1 mm thickness of packing
|
||
|
1.5% for each 2 mm thickness of packing
|
||
|
2.5% for each 2 mm thickness of packing
|
||