1. If the direction of flow of water is parallel to the planes of stratification, then the permeability is ........ times more than in a direction perpendicular to them ?

2 to 10

2 to 15

2 to 20

2 to 30

Answer: 2 to 30

Explanation:


2. Quick sand is a ?

moist sand containing small particles

condition which occurs in coarse sand

condition in which a cohesionless soil loses all its strength because of upward flow of water

none of the above

Answer: condition in which a cohesionless soil loses all its strength because of upward flow of water

Explanation:


3. The coefficient of consolidation is used for evaluating ?

stress in the soil

total settlement

over consolidation ratio

time rate of settlement

Answer: time rate of settlement

Explanation:


4. A fine grained soil ?

has low permeability

has high compressibility

may or may not be plastic

all of these

Answer: all of these

Explanation:


5. The critical gradient of the seepage of water ?

directly proportional to void ratio

increases with the decrease in void ratio

inversely proportional to specific gravity

increases with the decrease in specific gravity of soil

Answer: increases with the decrease in void ratio

Explanation:


6. Lacustrine soils are those soils which are ?

deposited in sea water

deposited at the bottom of the lakes

transported by running water

transported by wind

Answer: deposited at the bottom of the lakes

Explanation:


7. Residual soils are ?

sands

silts

clays

all of these

Answer: all of these

Explanation:


8. The ratio of the unit weight of soil solids to that of water is called ?

void ratio

porosity

specific gravity

degree of saturation

Answer: specific gravity

Explanation:


9. The approximate void ratio in sandy soils is ?

0.2

0.6

0.8

1.2

Answer: 0.6

Explanation:


10. The moisture contents of a clayey soil is gradually decreased from a large value. The correct sequence of the occurrence of the limits will be ?

liquid limit, plastic limit and shrinkage limit

plastic limit, liquid limit and shrinkage limit

shrinkage limit, plastic limit and liquid limit

plastic limit, shrinkage limit and liquid limit

Answer: liquid limit, plastic limit and shrinkage limit

Explanation: